So, this was actually the first project that I ever purchased through Darby Smart, but since I was one jumping short, and the last half of the year is always more hectic than the first… I was significantly delayed.
Step 1 | Plan out your design. I was going for two different looks. One more vintage, another a bit more modern.
Step 2 | Glue the buttons to the felt.
Note: Make sure you are in a well ventilated area because the glue is extremely strong.
Step 3 | After allowing the glue plenty of time to dry, cut around your design. Make sure to leave tabs to put your jump rings through.
Step 4 | Cut chain to desired length and thread through the loop. (You may want to do this differently, I was going for a double chain look.)
Step 5 | Attach jump ring at one end of chain, and attach other jump ring and lobster clasp to other side of chain.
Looking for the perfect DIY project to suit you? Check out Darby Smart here.